site banner

Tinker Tuesday for September 2, 2025

This thread is for anyone working on personal projects to share their progress, and hold themselves somewhat accountable to a group of peers.

Post your project, your progress from last week, and what you hope to accomplish this week.

If you want to be pinged with a reminder asking about your project, let me know, and I'll harass you each week until you cancel the service

2
Jump in the discussion.

No email address required.

The adjustment screws on those controllers are almost always simple multi-turn potentiometers, so it's a little weird to see voltage wobble even if one breaks off entirely. Lower-end buck converters can sometimes act up if you try to calibrate them without a load. Putting a 2.5-5k ohm resistor (for 12v, this should keep under 1/8th watt) on the output side may be worth a shot.